How about replacing the slider switch with a SPDT relay. You can then
install a switch to control the relay and put it anywhere.
Carl Moreschi N4PY
121 Little Bell Drive
Bell Mountain
Hays, NC 28635
----- Original Message -----
From: "Michael, Dana A" <dana.michael@tycoelectronics.com>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Wednesday, January 04, 2006 7:04 AM
Subject: Re: [TenTec] Corsair II receieve ant switch
> Hi Paul,
> I ran a very small screw (0-80 or 2-56)into the the switch lever so that
> you could reach around the rig and fell the screw head and switch the RX
> antenna input on when needed. I know its not a front panel switch but it
> worked for many years on my Corsair II for use with a QSK amp and RX
> antennas for 160M.
>
> 73, Mike W3TS
>
> -----Original Message-----
> From: tentec-bounces@contesting.com
> [mailto:tentec-bounces@contesting.com] On Behalf Of Paul DeWitte K9OT
> Sent: Saturday, December 31, 2005 3:15 PM
> To: tentec@contesting.com
> Subject: [TenTec] Corsair II receieve ant switch
>
> Has anyone modified their Corsair II (or any other model with the
> switch in
> back) receieve ant switch so it is more accessable from the front? I
> would like to chose either TX ant or RCV ant without moving the radio
> out of its slot to switch between the two. In a contest situation this
> would be unacceptable and slow.
>
> Thanks 73
> Paul K9OT
>
>
>
> --
> No virus found in this outgoing message.
> Checked by AVG Free Edition.
> Version: 7.1.371 / Virus Database: 267.14.9/217 - Release Date: 12/30/05
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|