Ron, Do you notice any loss of signal audio when turning the BW encoder
from 200hz to 100hz in the cw mode? Not the signal strength but the
audio itself. I seemed to notice loss of audio the last time I operated the
O2.
----- Original Message -----
From: "Ron" <ron@morell.us>
To: <tentec@contesting.com>
Sent: Friday, December 23, 2005 6:06 PM
Subject: [TenTec] Initial comments about ORION II
> My ORION II arrived yesterday and 15 seconds later it was out of the box
and
> on the air. I tried it out for several hours yesterday and set it up in
all
> the configurations that caused problems with the ORION. It did not
develop
> any anomalies that I could detect. As I currently operate this radio, it
is
> flawless. I've operated binaural CW with sweep on at the different
levels,
> I've operated CW and PSK, while listening to AM broadcast radio on
receiver
> B with the sweep on, and a variety of other settings that have caused the
> ORION running the latest version 1.3 software to either stop transmitting,
> or stop receiving on Receiver B.
>
> It is a little disappointing, that I'm not yet challenged with software
> anomalies whilst operating the O2. Maybe someone would enlighten me and
> tell me what parameters are needed to create a fault in this version of
> software? Perhaps if I read the manual, and consider the instruction
there,
> I'll find a way to create a fault.
>
> I really like this radio and wish all on the reflector and all the folks
at
> Ten Tec a Merry Christmas and a happy New Year! And thanks for building
> this great radio.
> 73
> Ron KA7U
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|