Thanks to all who answered my question on Digital readout for the
Argonaut 509.
Rich...WD6DOK
-----Original Message-----
From: tentec-bounces@contesting.com
[mailto:tentec-bounces@contesting.com] On Behalf Of k8bbm
Sent: Thursday, November 17, 2005 7:58 PM
To: Discussion of Ten-Tec Equipment
Subject: Re: [TenTec] Digital readout for the Argonaut 509.
There wasn't one specific for 509, but lots of folks have
used the digital readout from Oak Hills Research/Milestone
Technologies - see link at www. qrparci.org site
Dave K8BBM
----- Original Message Follows -----
From: "Stuart Rohre" <rohre@arlut.utexas.edu>
To: "Discussion of Ten-Tec Equipment"
<tentec@contesting.com>
Subject: Re: [TenTec] Digital readout for the Argonaut 509.
Date: Thu, 17 Nov 2005 18:25:40 -0600
>
> I have never seen a digital readout from Ten Tec for the
> 509. Maybe there was a third party one??
>
> Stuart
> K5KVH
>
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|