I'd just stick with the filters that were intended for each slot. Each slot
has specific component matching for the intended filter.
Barry N1EU
On 11/18/05, k8bbm <k8bbm@srt.com> wrote:
>
> Hi, just got a Corsair II -
> need suggestions about filtering for a casual contester, cw
> rag chewer, casual dx-er..
> Manual says on SSB, filter selection is the stock 2.4 and
> the next two positions
> on CW, filter selection is one after the 2.4 and next two
> positions...
> I don't like the 250 hz filter, am thinking of INRAD and
> doing the following
> 2.4 xmit/receive (stock) - then 2.4 inrad and 2.1 inrad
> in the 1.8 and 500 hz slots, Then put 400 hz INRAD or the
> 500 hz TT in the 250 hz slot -
>
> or would you put a narrow ssb filter in the 1.8 slot, then
> 500 tt in the 500 slot, the 400 inrad in the 250 slot?
> Your advice?
> thanks
> Dave K8BBM
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|