TenTec
[Top] [All Lists]

Re: [TenTec] 6 Meter Operation

To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: Re: [TenTec] 6 Meter Operation
From: "Dave, K2DP" <k2dp@charter.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Thu, 10 Nov 2005 22:02:54 -0600
List-post: <mailto:tentec@contesting.com>
Rich,

6 meters is a band for a beam. Yes, you might make some contacts with your 
wire antenna, however, most folks on 6 meters use a minimum of a 3 element 
beam at 30 feet, providing both gain and directivity. You will become 
quickly frustrated with the band using a wire antenna. Until the sporadic 
e-season comes around in May 2006, most of what you will hear and work will 
be ground wave signals. With your wire, you will be limited to working folks 
within a very short range 10-15 miles, max. Also, the low power output of 
the transverter will not help either. Try to pick up a used solid state 6 
meter amp such as the Mirage amps, 5 watts in/ 125 watts out. Put that 
together with your beam and you will enjoy 6 meters year round.

73 and have fun,
Dave, K2DP, St. Louis
----- Original Message ----- 
From: "Knox, Richard L." <richard.knox@gd-ais.com>
To: <tentec@contesting.com>
Sent: Tuesday, November 08, 2005 1:49 PM
Subject: [TenTec] 6 Meter Operation


> TT Folks:
>
>
>
>  I have just purchased a TT Model 1208 6 Meter Converter and would like
>
> some guidance on an antenna system for operating on 6 Meters...something
>
> I have never done before.  I currently have a 300 foot horizontal loop
>
> antenna up about 25 feet which is fed by 50 feet of RG213, fed by a TT
>
> 238B tuner with an Omni VI+ upstream.  Before I build a dedicated 6
> Meter
>
> antenna system I wonder if there is any possibility that my current loop
> antenna and matching system could be used for 6 Meter operation?
> Appreciate any advice and
>
> guidance you can share.
>
>
>
>  Thanks and 73!   de KD4BRL  Dick Knox
>
>
>
>
>
> COL(R) Richard L. Knox
>
> Transportation Security Solutions
>
> Analytic Systems Group
>
> Homeland Security and Assurance
>
> General Dynamics
>
> 1200 Joe Hall Drive
>
> Ypsilanti, Michigan 48197
>
> Tel:  734-480-5197
>
> Fax:  734-480-5781
>
> E-mail:  Richard.Knox@gd-ais.com
>
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
> 
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>