TenTec
[Top] [All Lists]

Re: [TenTec] Omni VI+ Filter configuration

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] Omni VI+ Filter configuration
From: Robert & Linda McGraw K4TAX <RMcGraw@Blomand.Net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Mon, 07 Nov 2005 09:40:27 -0600
List-post: <mailto:tentec@contesting.com>
The standard filter is a 2.4 KHz in the 6.3MHz IF.  Optional slots which are 
marked but not filled from the factory are:  1.8 KHz, 500 Hz, and 250 Hz. 
The 9 MHz IF has slots marked N-1 and N-2.  All are labeled likewise on the 
front panel.

The 6.3 MHz optional filter are as follows:  1.8 KHz is model 288, the 500 
Hz is model 285, and the 250 Hz is model 282.

For the 9 MHz IF the optional filters are: models, 216, 217, and 219 which 
require the high gain setting by moving a jumper pin.  The models 218 and 
220 use the low gain setting.  The jumpers are located adjacent to the 
filter locations and are marked JG1 and JG2.

Optional filter specifications:
9MHz IF filters -
216 - 500 Hz 6 pole for FSK
217 - 500 Hz 8 pole for CW ** N-2
218 - 1.8 KHz 8 pole for SSB ** N-1
219 - 250 Hz 6 pole for CW
220 - 2.4 KHz 8 pole for SSB

6.3 MHz IF filters -
282 - 250 Hz 6 pole for CW **
285 - 500 Hz 6 pole for CW **
288 - 1.8 KHz 8 pole for SSB **

Hope this helps.  The ** after the filter is the way I have mine configured 
and it's great!

73
Bob, K4TAX



----- Original Message ----- 
From: "NJ0IP" <Rick@DJ0IP.de>
To: "'Discussion of Ten-Tec Equipment'" <tentec@contesting.com>
Sent: Monday, November 07, 2005 9:20 AM
Subject: [TenTec] Omni VI+ Filter configuration


> Pse help me out here.
>
> It's been 2 years since I had an Omni VI+.
>
>
>
> Please define for the VI+ (original - not the upgraded ones) what the
> optional filter possibilities are.
>
>
>
> As I recall, standard was 2.4 kHz in the 9MHz and 2.4 kHz in the 6.3 MHz
> IFs.
>
> Then there were 3 + 2 optional slots (5 total).
>
> How many were in the 9MHz IF and how many in the 6.3 MHz?
>
>
>
> One of the IF's had its filter slots labeled.  Which one was that?
>
> The other IF just had two slots (Nar1 and Nar2).
>
>
>
> Thanks for the help.
>
>
>
> 73
>
> Rick
>
> DJ0IP
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
> 


_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>