Hehehehee.....I think that "put in a load" meant he did a load of
wash....not inserted a dummy load in the antenna line. Of course I could be
wrong.
73 de Gary. AA2IZ
----- Original Message -----
From: "Robert & Linda McGraw K4TAX" <RMcGraw@Blomand.Net>
To: "Tentec" <tentec@contesting.com>; <richardcardwell@adelphia.net>
Sent: Tuesday, September 27, 2005 12:23 PM
Subject: Re: [TenTec] Whirlpool Duet, Neptune, Orion
> Rich:
>
> The fact that you did not observe any interference is attributed to the
fact
> that your load does not radiate nor does it receive for that matter.
That's
> an indication of a good load.
>
> Now, in most cases the control system of the washer does cause the chopped
> AC to create a good bit of noise on the HF bands. The fact that it is on
a
> different circuit from the radio has little to no bearing on it either.
The
> neutral is common to both sides of the line and the neutral, depending on
> load balance, is always a few millivolts above true ground. A few
> millivolts will radiate.
>
> I'd expect if you have a antenna near the washer you'd hear the noise. One
> of the other folks that complained indicated that his vertical is outside
> the wall where the Duet is located. In another case, the fellow has his
ham
> shack in the same room as the laundry equipment.
>
> If you aren't bothered with it then good, don't consider "fixing it". On
> the other hand, these machines do have controllers that cause and radiate
RF
> emissions. The controller takes the 120VAC single phase and converts it
to
> 3 phase, quasi sine, to control the motor speed and direction. There are
> steps that can be implemented to improve, reduce or totally correct the
> issue. These include adding filtering in the form of common mode chokes.
> Unfortunately, the manufacturer does not have any support in this area so
> you are on your own. The problem does not really come under FCC
compliance
> unless an official complaint is filed and even then, one could expect
little
> action.
>
> 73
> Bob, K4TAX
>
>
> ----- Original Message -----
> From: "Richard Cardwell" <richardcardwell@adelphia.net>
> To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
> Sent: Tuesday, September 27, 2005 8:35 AM
> Subject: Re: [TenTec] Whirlpool Duet, Neptune, Orion
>
>
> > We have had a Duet Washer for two years now and I never noticed any
> > interferrence. So after following this discussion for a while, I put in
a
> > load and listened to 20m and 40m with the result that there is NO
> > dedectible interferrence. Am I missing something here? My rig is on a
> > separate circuit so maybe that is a factor.
> >
> > Good news for a change.
> >
> > Rich, AA2BY
> >
> >
> > _______________________________________________
> > TenTec mailing list
> > TenTec@contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
> >
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|