Larry / W1GOR,
T238B Manual, Chapter 1, Section 1-5, Part C:
"For balanced feedline systems, add a jumper from SINGLE WIRE to one of the
BALANCED LINE terminals as shown on the rear panel, using a short wire. Then,
connect the feedline to the two BALANCED LINE terminals."
That's exactly what I did.
JDC
W1GOR W1GOR at Maine.RR.Com Sat Sep 24 13:51:38 EDT 2005 a.. Previous message:
[TenTec] TT 238B Question(s) b.. Next message: [TenTec] TT 238B Question(s) c..
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] You stated, "I
have the transmission line connected to the balanced inputs
plus the extra wire going from one balanced terminal to the single-wire
terminal."
Why is the "...the extra wire going from one balanced terminal to the
single-wire terminal." ??? It seems to me that this 'extra wire' is
unbalancing a balanced feedline.
Re-read the TT instruction manual... Try removing the "extra wire"...
73, Larry - W1GOR
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|