Rick,
I recently had 2 antennas and 2 rigs wired through 2
switches.
The first switch is a B&W 6 position antenna switch
with 1 common(rig) outlet that was connected to the
common (rig) input to a TT Model 228 tuner.
The DL (dummy load) connection went to the #1 rig and
the Bypass connection went to the #2 rig.
My #1 antenna is a G5RV with an RT-11 remote tuner
attached outside and the #2 antenna is my 180 ft
horizontal loop rain gutter with an AT-100 Pro tuner
attached in the shack.
I could switch the 2 antennas between the rigs or
switch the rigs on 1 antenna. The latter is very handy
for comparing the receiver performance of 2 rigs.
Regards,
Don NN8B
Date: Fri, 9 Sep 2005 21:54:17 EDT
From: WO8L@aol.com
Subject: [TenTec] Antenna Switch
To: tentec@contesting.com
Message-ID: <15d.58ab82c8.305396c9@aol.com>
Content-Type: text/plain; charset="US-ASCII"
Hi,
Anybody out there using an antenna switch to match two
antennas to two
rigs?
Or using two switches to match two antennas to two
rigs?
73s,
Rick
WO8L
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|