| To: | Luca <ik5tsw@virgilio.it>, Discussion of Ten-Tec Equipment <tentec@contesting.com> |
|---|---|
| Subject: | Re: [TenTec] paragon audio noise in trasmission |
| From: | Robert & Linda McGraw K4TAX <RMcGraw@Blomand.Net> |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Thu, 08 Sep 2005 15:32:54 -0500 |
| List-post: | <mailto:tentec@contesting.com> |
Luca:Check to see that you are getting a mute voltage transition at connector 44 pin 2 on the IF/AF board. If so then most likely Q12 has failed or D9 is shorted thus not allowing muting of the audio output stage U10. Input audio to U1 is supplied via pin 3 of connector 55 and is muted by Q12 conducting to ground. Before you dig too deep be sure all the connectors are well seated. It wouldn't hurt to carefully unplug connector 44, 48, 55 and 50 and then reconnect just in case there is a dirty contact on the mute or ground lines to the AF/IF board. The current levels are very low in this circuit and thus not enough voltage to create a "punch" through on an oxidized connector. 73 Bob, K4TAX----- Original Message ----- From: "Luca" <ik5tsw@virgilio.it> To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com> Sent: Thursday, September 08, 2005 2:47 PM Subject: [TenTec] paragon audio noise in trasmission Luca wrote:Hi to All I am new member of this very intresting mail list . I have purchase second hand Paragon 585When trasmitting i have the distorted audio in a speaker ,is a truble ? Or is normal ?You have a possible remedy ? Sure of your intresting many thanks in anvance 73 Luca _______________________________________________Luca: Just turn down the monitor control on the back panel. This is a voice sidetone for checking the speech processor, but it isn't particularly useful. 73, Bob WB2VUF Make sure that the MONITOR level control on the rear panel is turned down. 73 Bob, K4TAX Luca wrote: Many thanks to all for your answerIn my Paragon the MONITOR LEVEL , AF GAIN , RF GAIN ore in max counter-clockwise ad i use the dummy loadThe problem to decrease if i turned down the RF POWER ad increase in lower bandI think the RF retur Many thanks in advance Luca ik5tsw@virgilio.it______________________________________________________________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | [TenTec] paragon audio noise in trasmission, Luca |
|---|---|
| Next by Date: | Re: [TenTec] paragon audio noise in trasmission, Robert & Linda McGraw K4TAX |
| Previous by Thread: | [TenTec] paragon audio noise in trasmission, Luca |
| Next by Thread: | Re: [TenTec] paragon audio noise in trasmission, Robert & Linda McGraw K4TAX |
| Indexes: | [Date] [Thread] [Top] [All Lists] |