TenTec
[Top] [All Lists]

Re: [TenTec] Astron RS-35M and Omni VI

To: tentec@contesting.com
Subject: Re: [TenTec] Astron RS-35M and Omni VI
From: Duane A Calvin <ac5aa@juno.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sun, 31 Jul 2005 22:34:16 -0500
List-post: <mailto:tentec@contesting.com>
My RS-35M was old and worn when I bought it over 10 years ago, and it's
still going strong.  Lots of RF in the shack, but no problem for the
Astron (and the negative post has never been tied to the chassis).  Power
switch is still going strong too.  I avoid the powering on/off problem by
leaving it on ALL THE TIME except when I'm going on vacation for a week
or more.  I got into the habit when I had the Omni VI+ to keep the
crystal oven on, but even now with my Orion, I just leave the power
supply on all the time.  I've seen no ill effects from this practice (so
far!).

        73,  Duane
P.S.  I have found that crowbar works on lightning pulses - it crowbarred
twice this past week.  The first time in the 10 years I've owned it! 
They were REALLY close strikes.  


On Sun, 31 Jul 2005 22:01:24 -0500 "Byron J. Watts" <bjw@byron.com>
writes:
> i have ~heard~ a complaint that the Astron's only weakness is in it's 
> AC 
> line switch, it dies after several hundred operations, the rest of 
> the 
> supply will be fine but the switch will be shot.  if you have 
> another 
> way of killing the power supply itself this would effectively bypass 
> 
> that problem.  like i said, heard, not experienced.
> 
> KC0NPF
> 
> Carl Moreschi wrote:
> 
> >I think it is best to always have the supply on first and off last. 
>  I think
> >it is a good thing to turn the Corsair on and off with a power 
> strip and
> >have the supply already on.
> >
> >Carl Moreschi N4PY
> >Franklinton, NC
> >----- Original Message ----- 
> >From: "Don Rasmussen" <wb8yqj@yahoo.com>
> >To: <tentec@contesting.com>
> >Sent: Sunday, July 31, 2005 10:21 PM
> >Subject: [TenTec] Astron RS-35M and Omni VI
> >
> >
> >  
> >
> >>Would anyone suggest that using a power strip as the
> >>on/off switch for your Corsair II (always on) supplied
> >>by an RS35 (switch on)is a bad thing?
> >>
> >>I have an airpax that I normally use as the on/off
> >>switch after the RS35A is already powered up at the
> >>main station position, but not at the secondary
> >>position.
> >>
> >>I am wondering if allowing the gear to shut down
> >>slowly as the RS35 filter caps drain is harder on the
> >>gear at the secondary station than the primary. Astron
> >>is also not stabilized at rig power up that way.
> >>
> >>_______________________________________________
> >>TenTec mailing list
> >>TenTec@contesting.com
> >>http://lists.contesting.com/mailman/listinfo/tentec
> >>    
> >>
> >
> >_______________________________________________
> >TenTec mailing list
> >TenTec@contesting.com
> >http://lists.contesting.com/mailman/listinfo/tentec
> >
> >
> >
> >  
> >
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> com/mailman/listinfo/tentec
> 
> 


--------------------------------------
Duane Calvin, AC5AA
Austin, Texas

http://home.austin.rr.com/ac5aa
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>