TenTec
[Top] [All Lists]

Re: [TenTec] Vertical

To: "'Discussion of Ten-Tec Equipment'" <tentec@contesting.com>
Subject: Re: [TenTec] Vertical
From: "NJ0IP" <Rick@DJ0IP.de>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Fri, 15 Jul 2005 00:16:55 -0700
List-post: <mailto:tentec@contesting.com>
I think you will be pleasantly surprised how well it works like that, rather
than horizontal.

-----Original Message-----
From: tentec-bounces@contesting.com [mailto:tentec-bounces@contesting.com]
On Behalf Of CATFISHTWO@aol.com
Sent: Thursday, July 14, 2005 12:15 PM
To: tentec@contesting.com
Subject: Re: [TenTec] Vertical

 
I have a cushcraft d-4 on the ground, It is a 10-40 m rotatable dipole. I
am 
curious  of how this would work as a vertical.
 
I think I would have to tie some nylon guys to the top to stabilize  it,  
lets say nail a 4X4  8 feet long of the end of the peak of the  roof
sticking out 
say 4 feet.. mount the D-4  in the middle  pointing  up and down,  run the 
feed line at 90 degrees away down the  roof peak  then turn and run down to
the 
shack.
 
I understand there would be some interaction  with the wire in the  stucco
on 
the bottom, but do you think it would work, and how well, ??
 
Any thoughts..
 
tom N6AJR
 
 
 
 
 
 
In a message dated 7/14/2005 10:58:04 A.M. Pacific Standard Time,  
ghoffman@spacetech.com writes:

Yes  indeed.  Or one could go back and speak to Mr. Marconi himself, for
whom
the vertical antenna bearing his name was of course, well, er,  named.  :)

Your point (and others) being that the vertical antenna  is one of the
oldest, and one of the historically most successful antennas  ever created.
Not the best one of course, but a solid performer, simple,  and inexpensive.




_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec


_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>