In a message dated 6/4/2005 9:57:20 P.M. Eastern Daylight Time,
longpond@downeast.net writes:
Just picked up an Omni D series B and need to know what pot is the
adjustment for the S meter. No book as yet. Jim K1QCF
...................................................................
Jim,
The adjustment procedure goes like this:
Remove top cover. Apply 50 uV signal at 14,1 MHz to antenna terminal and
adjust RESONATE control and MAIN TUNING for S-Meter peak. Set pot R20 on the
IF-AGC board for S-9 reading. ( Just forward of the 8 pole xtal filter)
Bill K3UJ
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|