To: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
---|---|
Subject: | Re: [TenTec] SSB recieve audio? |
From: | Barry Gross <barry.n1eu@gmail.com> |
Reply-to: | Barry Gross <barry.n1eu@gmail.com>,Discussion of Ten-Tec Equipment <tentec@contesting.com> |
Date: | Sun, 29 May 2005 14:43:51 +0000 |
List-post: | <mailto:tentec@contesting.com> |
On 5/29/05, Steve N4LQ <n4lq@iglou.com> wrote: > I did some measurements on the Omni VI. Nothing below 300hz get's past the > detector. The notch and DSP are not to blame. It has to do with the position > of the BFO within the IF passband. The lower cutoff of the audio passband (after the detector) is easily adjusted by alignment. _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
Previous by Date: | Re: [TenTec] SSB recieve audio?, Steve N4LQ |
---|---|
Next by Date: | Re: [TenTec] SSB recieve audio?, Steve N4LQ |
Previous by Thread: | Re: [TenTec] SSB recieve audio?, Steve N4LQ |
Next by Thread: | Re: [TenTec] SSB recieve audio?, Steve N4LQ |
Indexes: | [Date] [Thread] [Top] [All Lists] |