TenTec
[Top] [All Lists]

Re: [TenTec] Orion TX Audio Settings

To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: Re: [TenTec] Orion TX Audio Settings
From: "John Embry" <rtecw1@charter.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Thu, 12 May 2005 15:55:46 -0500
List-post: <mailto:tentec@contesting.com>
It depends on your mike and your voice , There is a section in the manual on it,I set my rcvr bandwidth around 2400 and my transmit bandwidth just a bit higher. my LF rolloff is 50 hz and the tx ex at -17db and rcvr ex at 0 db. Again the type mike plays an important part in the settings. I am using the Heil Studio one,but your receiver audio should be very good.
JOHN W4RTE
----- Original Message ----- From: "Grant Youngman" <nq5t@comcast.net> To: "'Discussion of Ten-Tec Equipment'" <tentec@contesting.com>; <ssbaudio@yahoogroups.com>
Sent: Thursday, May 12, 2005 3:17 PM
Subject: Re: [TenTec] Orion TX Audio Settings


Well, it depends on your mic and your voice.

I normally keep my TX EQ at between -14 to -18. Way too bassy with TX EQ at
0.  SSB bandwidth settings vary by mode (SSB, AM).  If the band isn't
crowded or I'm on AM I leave it at 50/3900.  Otherwise at maybe 150/3000.
And then there are the 60M rules, etc.

The same values work whether I'm using a Studio One through the mic
connector or an EV RE-20 and audio rack through the AUX port.

Audio reports are always good, especially wide open.  It's pretty easy to
judge for yourself using the MON function.

Grant/NQ5T

-----Original Message-----
From: tentec-bounces@contesting.com
[mailto:tentec-bounces@contesting.com] On Behalf Of Manuel Alonso
Sent: Thursday, May 12, 2005 1:04 PM
To: tentec@contesting.com; ssbaudio@yahoogroups.com
Subject: [TenTec] Orion TX Audio Settings

Hello,

Have owned an Orion for a while, but never get good audio
reports like I get with my TS-850/DSP-100 or even my ProIII.

I have tried the Orion with the Heil PR-40 as well as with my
"audio rack" with no success.



What are the ORION settings such as bandwidth, tx rolloff,
and TX eq that work the best for other users.

Manny

KC4MNE

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec



_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec




<Prev in Thread] Current Thread [Next in Thread>