I was thinking along the lines of the strong signal 'popping' and some
mention of increasing sensitivity with a diode swap---not that the old Omni
needs too much help in that regard.
scott VA3ZW
----- Original Message -----
From: "Steve Baron - KB3MM" <SteveBaron@StarLinX.com>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Friday, March 25, 2005 11:38 PM
Subject: Re: [TenTec] Omni C mods
> Mods to accomplish what ?
>
> ----- Original Message -----
> From: "Scott Sheppard" <scottsheppard@videotron.ca>
> To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
> Sent: Friday, March 25, 2005 17:30
> Subject: [TenTec] Omni C mods
>
>
>> Hi,
>> As a recent owner of an Omni C I am curious to know if there are some
>> mods
> out there that may be worth looking at. I had heard even something as
> simple
> as switching some of the diodes? If someone can forward or direct me to
> where these mods may be I would be most appreciative.
>>
>> 73 Scott VA3ZW
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>>
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|