TenTec
[Top] [All Lists]

Re: [TenTec] Rig changes

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] Rig changes
From: Jerry Volpe <kg6tt@tomorrowsweb.com>
Reply-to: kg6tt@tomorrowsweb.com,Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Wed, 23 Mar 2005 09:43:03 -0800
List-post: <mailto:tentec@contesting.com>
Ben K8DIT wrote:

>If once you have the Jupiter you are plagued with BCB front end overload,
>simply place a high pass filter ahead of the transciever. I use an ICE 402X,
>there are others, or, build one to suit if you are so inclined. I too like
>the Omni D and the Omni VI for their featureful design. I also like  the
>Scout.
>The only other transciever I use the high pass BCB filter is with the Scout
>on 160, where w/o it
>there resides a cacaphony of mixer products that overload the front end when
>I use my L network tuned inverted-L as the antenna of choice. With the high
>pass filter, no overload and no mixer products reach the reciever.
>Simply, if there is front end energy on any band that overloads it, the
>reciever is compromised.
>Removing that spike of rf energy by attenuating it allowing the very fine
>design elements of the Jupiter to function normally. +
>
>
>_______________________________________________
>TenTec mailing list
>TenTec@contesting.com
>http://lists.contesting.com/mailman/listinfo/tentec
>
>
>  
>
I added the ICE Model 400x after all my transceivers to quelch the BCB 
interference. This filter allows you to transmit through it as well as 
receive. The cut off is kind of high so 160 is useless, but I don't have 
space for a 160m antenna so not a problem here. My point should have 
been that the Jupiter was by far the worst of all my transceivers where 
BCB interference was concerned and that it wasn't useful for me without 
the external filter. This was NOT the deciding factor me.... it was the 
lack of a hardware noise blanker. The DSP derived noise blanker has no 
effect on my electrical noise here whereas the hardware noise blankers 
in my Scouts, Paragon, Omni-VI+, and Omni-C were very effective. I 
didn't find the Jupiter's DSP Noise Limiter particularly effective on 
this noise either.

What I did like about the Jupiter:
1. The ability to broaden the receive bandwidth for ragchew listening.
2. Extreme stability
3. Perfect bandwidth control for digital reception (PSK, etc.)
4. Software control flexibility
5. Internal antenna tuner
6. Remote keypad/tune control

My negative issues other than what I mentioned before were mostly 
concerning somewhat poor ability to function properly within strong RF 
environments (even its own under some conditions), the poor quality of 
controls and the Jupiter's somewhat weak-contrast display.

Oh, I have owned an RX-350 for over two years now which has virtually 
the same receive section as the Jupiter.... so I remain familiar with 
how the Jupiter works in comparison with my other Ten-Tec transceivers.

(I actually use my Paragon the most.... go figure).
73,

Jerry, KG6TT
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>