this NB thread reminded me to email "my" contact at ComED, as I have S9
noise in two different directions !!!! I was always amazed at how well
the onni6+ NB worked. Better than my Icom 756P2 ,,, as good as My K2...
which is fantastic. ( in fact I wrote a letter to Inoue before the release
of 7800 suggesting he tell his guys to make it the best NB. I did get a
written reply from Japan !!! very nice letter, and in fact have maintained
email communications since then.)_
Anyhow i emailed my Comed contact....and need to share it with you.
YOU NEED TO BE NICE AND COMMUNICATE WITH YOUR UTILITY.
YOU WILL GET RESULTS,,, If you can figure how to be both persistent AND
NICE. I was able to make these guys understand that I KNEW WHAT I WAS
TALKING ABOUT ..it messes up my equipment & that I truly appreciated their
assistance.
The engineering guys write up repair orders,,,, they don't seem to be
sensitive to a budget for repairs of busted distribution components. (
which are the reason for my problems).
Previously i was able to take them to the exact poles... prior to them
aiming their Radar Devices Ultrasonic parabolic dishes to the bad
component/s on the poles.
check out this set of emails...
-----Original Message-----
From: Bill Steffey
Sent: Friday, March 18, 2005 10:38 AM
To: the guy at comed,,,,,,,,,,,,,,,,,,,,,,
Subject: RE: noise again
help.....
I AM GETTING INTERMITTENT LARGE NOISE FROM THE OLD AREA..
and the noise from the east is now continuous.....
Pse adivse,,,,
+++++++++++++++++++++++++++++++++++++++++++++++
to me from the Comed guy....
I will come out next week sometime. I'll inform you of the day when I know
for sure, Probably Tuesday.
********************************
previous email response to earlier problem::::
>Bill,
>I went out there this afternoon and found that they had done all the work
>that we had asked. Then I took out the dish and found 2 additional spots
on
>different poles, so I'll put another request in right away
SO DON'T GIVE UP....
REMEMBER THE FCC NAILED PACIFIC GAS & ELECTRIC FOR IGNORING A HAMS PLEA
FOR REPAIRS,,,,,$$$$$$$$$$$$$$$$$
BILL
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|