Hi George,
I don't know what to say about the volume control situation, but I have
observed the same behavior as you regarding the
receiver antenna selection situation. As always, an antenna driving 2
separate loads simultaneously will deliver less voltage into each one of
them than when driving either one alone.
However, I've yet to find a situation where this compromised the ability of
the Orion to hear a signal.
I've observed this behavior in all versions of the software that I have
gone through, going all the way back to 1.340.
73,
Mike Gorniak
NM7X
(Original Message)
Date: Sun, 13 Mar 2005 10:41:59 -0500
From: "George K" <w2yj@highstream.net>
Subject: [TenTec] ORION_ANT_SELECTION
Orion owners.
I have noticed a problem with my Orion running on the latest firmware,
1.372. I never had the previous version as it was loaded at the factory.
When I switch the sub receiver to ant 2, that's where my beam is connected,
I notice a slight decrease of signal on the main receiver??? Is it the
loading of the sub receiver on the main receiver doing this. Is this normal?
I also get blasted out of my shack with the audio volume reverting to full
volume. I madly reach for the off button as my ears are near bleeding from
the blast! This happens, as I can remember, when I turn up the volume.
Turning it back on relieves this annoyance. This is a very infrequent affair.
The other small annoyances I can live with, so far.
George W2YJ
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|