TenTec
[Top] [All Lists]

Re: [TenTec] Where have I been so long? Should I use dedicatedcomputer?M

To: <larrylg1@roamer.net>,"Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: Re: [TenTec] Where have I been so long? Should I use dedicatedcomputer?My Argo V delight.
From: "Mark Erbaugh" <mark@microenh.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Mon, 7 Mar 2005 10:14:31 -0500
List-post: <mailto:tentec@contesting.com>
Larry,

Glad you're on the mend.

Since your other computer has such a large hard drive, I'm assuming it's of
fairly recent vintage and thus of pretty decent processor horsepower.  What
do you want to do with the computer and the Argonaut V?  Most of the uses I
can think of rig control or logging software or digital mode operation can
probably be done with your existing computer assuming it is not too busy
doing other things at the same time.  Probably the most limiting resource
will be serial ports - in the worst case, I can see that you would need 3

1) Argonaut V control / logging
2) Digital mod PTT control (with suitable software there are ways around
this one)
3) Rotator control

Serial ports can be a scarce commodity. I have tried a couple of USB /
Serial port adapters and found that they will work for some things and not
others, and not necessarily the same things with different adapters.  I have
had pretty good luck using them for PTT control.

73,
Mark

----- Original Message ----- 
From: "Larry Greenberg N5BEA" <larrylg1@excite.com>
To: <tentec@contesting.com>
Sent: Sunday, March 06, 2005 2:29 AM
Subject: [TenTec] Where have I been so long? Should I use dedicated
computer?My Argo V delight.


>
>  This Ham greatly appreciates the reflector.  After much advice and
discussion I brought together all the goodies to assemble my low power dream
station. An Argo V, with the matching supply.  I have bought right off the
line an lightweight 20 meter mono band Hex Beam.  I shopped on line and got
a suitable TV rotor and software .. Thanks again to all of you for the
advice.   But, about a month before last Thanksgiving I under went some very
serious open heart surgery. You know, when they open up the chest and all
that. Well I am OK now, and am about ready to get  my beam in the air.  It
won't be too long.    I have some spare PC's and plenty of room on the hub
part of my router. I  wonder if it would be helpful if I dedicated one
completely to my ARGO. It is a very tight squeeze and the other PC in my
shack/office has 120 GIG hard disk with a lot of empty space. So, if it is
not of benefit, I could use the space. It is just that I have not been on
the air very much with "moder
>  n" equipment the last few years, so that's why I asking..  Larry
GreenbergN5BEA
>
> _______________________________________________
> Join Excite! - http://www.excite.com
> The most personalized portal on the Web!
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>