Re: [TenTec] Herc II and 9420 duty cycle

[Bill NY9H <ny9h@arrl.net>]

when i re fitted the outputs on my herc II; I recall my notes calling for bias
at .5 A per PAIR... ( 1/2 A per pair)
X 4 pair = 2 A ...

my Ic meter barely reads anything... i should think it should read closer 
to 2-3 A...
bill

At 12:52 PM 2/21/2005, you wrote:

> Hi Phil,
>
> Thanks for the suggestion.
>
> I see how the currents to the four PA modules is monitored by the
> voltage drop across the 0.015 ohm resistors on the DC Distribution
> Board, and then combined together to feed the Ic meter. And I see the