----- Original Message -----
From: <bobwhite@innercite.com>
To: <tentec@contesting.com>
Sent: Monday, February 14, 2005 19:28
Subject: Re: [TenTec] Orion Serial port
Hank,
Did you get it finally? The cable is a straight thru
Straight thru meaning?
Is one end DTE andd the other DCE ?
9 pin male on one side and
female on the other. I have been running my Alpha 99 on the second antenna
jack
(as the auto tunner is on ant one) and have only amp key 2 enabled with no
problems here. If you do any FSK you need to change the Mark high/low to
the
selection which is not the default to make it work, well, at least I did.
Every
answer seems to be in the manual somewhere, but not always obvious.
Good Luck with your new radio,
Bob WO3B
Quoting HENRY PFIZENMAYER <pfizenmayer@worldnet.att.net>:
> All of a sudden I realized I have no serial cables and I find nothing in
> the
> manual telling me what sex the serial port is on the Orion.
>
> Manual says "standard" DB9 serial cable. My computer is has the
> standard
> male DB9 serial port - what cable is needed to go to the Orion ?
> Straight
> thru /null modem or what ????
>
> I just realized that in about 20 some years of using PC's I have never
> used
> anything but the parallel port !!!!
>
> Thanks -- Hank K7HP
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|