Mike the info you want is on the main / all-in-one Wiring diagram. In case
you don't have that here's the info:
Connector U comes off of the IF/AF board
Connector 33 comes off of the 9 MHz board
Connector 75 comes off of the TX Audio / BFO Board
Connectors S and T come off of the Low Level (Amplifier) Driver / Noise
Blanker Board
I hope this helps.
73,
Rick
VE7TK
Website: http://www3.telus.net/ve7tk
---------------------------------------------------------
To: tentec@contesting.com
Subject: [TenTec] Ten-Tec Omni V FM Module Info
From: Mike Webb <mikey6429@yahoo.com>
Reply-to: tentec@contesting.com
Date: Wed, 9 Feb 2005 09:31:41 -0800 (PST)
List-post: <mailto:tentec@contesting.com>
Could I get someone to look at their FM installation
package and tell me where the FM module connects in
the Omni V? My manual does not cover the FM module so
its not readily apparent. I want to know which
connectors on which cards are used to drive the FM
card and then receive the FM signal output.
I would appreciate it very much.
Mike KG4RQD
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|