KS2S sent me a copy of the high pass filter page for the Paragon.
D12 is clearly shown as a 1N4148.
D1 thru D8 are BA482. Not exactly a pin diode but close enough.
Which PIN diode did the PEG use ?
----- Original Message -----
From: "David McClafferty" <ve1adh@yahoo.ca>
To: <tentec@contesting.com>
Sent: Thursday, February 03, 2005 14:39
Subject: Re: [TenTec] Paragon question
> The original was probably a PIN diode. That's what is
> in the Pegasus. I was told by Tentec that I could use
> a 1N914/1N4148 as temporary replacement but that I
> should eventually get the proper replacement. I asked
> them to send one and a few days later it showed up in
> my mailbox, no charge. Give 'em a call, I'll bet they
> do the same for you.
>
> Dave, VE1ADH
>
> --- "ultrafixedwing@juno.com"
> <ultrafixedwing@juno.com> wrote:
> >
> > I replaced D12 on the HPF board with a 1N4148 diode
> > from Radio Shack. The original is a glass silicon
> > diode. Buck and a half for 10 of them. Seems to work
> > OK now. I'll keep my fingers crossed.
> > Paul
> > KS2S
> >
> >
> ___________________________________________________________________
> > Speed up your surfing with Juno SpeedBand.
> > Now includes pop-up blocker!
> > Only $14.95/month -visit http://www.juno.com/surf to
> > sign up today!
> >
> > _______________________________________________
> > TenTec mailing list
> > TenTec@contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
> >
>
> ______________________________________________________________________
> Post your free ad now! http://personals.yahoo.ca
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|