With a Bird 43 and then into a dummy load.
Tom
-----Original Message-----
From: tentec-bounces@contesting.com [mailto:tentec-bounces@contesting.com]
On Behalf Of K. Indart
Sent: Saturday, January 29, 2005 11:56 AM
To: tentec@contesting.com
Subject: RE: [TenTec] Omni VI Power Out
How are you measuring the power out ?
Ken
-----Original Message-----
From: tentec-bounces@contesting.com [mailto:tentec-bounces@contesting.com]On
Behalf Of Tom Lutz
Sent: Saturday, January 29, 2005 11:54 AM
To: tentec@contesting.com
Subject: [TenTec] Omni VI Power Out
My recently acquired Omni VI only gets about 80 watts out. I tried to
adjust R46 on the 9 MHz mixer/IF board per the instruction manual but it is
all the way against the stop and can't be turned up any more. Any ideas as
to what to do to get a full 100 watts out? I see there is a 15k fixed
resistor in series with R46, it's R45. Might this have changed value and
effected the total resistance?
Any help would be appreciated.
Tom, W0ZR
--
No virus found in this outgoing message.
Checked by AVG Anti-Virus.
Version: 7.0.300 / Virus Database: 265.8.2 - Release Date: 1/28/2005
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
--
No virus found in this incoming message.
Checked by AVG Anti-Virus.
Version: 7.0.300 / Virus Database: 265.8.2 - Release Date: 1/28/2005
--
No virus found in this outgoing message.
Checked by AVG Anti-Virus.
Version: 7.0.300 / Virus Database: 265.8.2 - Release Date: 1/28/2005
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|