Some time ago, TT told me that the speakers do go bad on the 960.
The bummer was that there was no way to fix/replace them due to the way they
were made. Replace ment of the whole front panel would be necessary.
Hope I remember that correctly.
Let us all know if I am all wet.
----- Original Message -----
From: "Stuart Rohre" <rohre@arlut.utexas.edu>
To: <tentec@contesting.com>
Sent: Thursday, January 27, 2005 21:44
Subject: Re: [TenTec] Omni VI & 960 Power Supply
> The raspy speaker in the power supply upon warm up sounds like warping of
> the speaker frame due to heat and unequal mounting bolt torque. Try
> loosening all the screws on speaker and then tightening just snug, while
> listening to it. Heat over time might have warped the voice coil, and in
> its throw, it is dragging at a point.
>
> If you cannot find any suitable torque, try another speaker temporarily
next
> to the faulty one. That should resolve any RF issue. Do not overly
torque
> speaker mountings especially when mounted in a cabinet with a heat source.
>
> -Stuart
> K5KVH
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|