TenTec
[Top] [All Lists]

Re: [TenTec] Titan 425 Works Fine but Started Blowing Fuses

To: tentec@contesting.com
Subject: Re: [TenTec] Titan 425 Works Fine but Started Blowing Fuses
From: Joe Giacobello <k2xx@swva.net>
Reply-to: k2xx@swva.net, tentec@contesting.com
Date: Thu, 20 Jan 2005 11:32:50 -0500
List-post: <mailto:tentec@contesting.com>
I have heard from the previous owner of my 425 that if the final tubes are not securely seated in their sockets, it can cause serious problems similar to what you're describing. If you haven't, you ought to take a look.

73, Joe

GARY HUBER wrote:

One thing to look for on amps with external anode tubes is a lite coat of dirt on the tube "seal" providing an arc path between the HV anode (PLATE) and the chassis / tube socket ground. Used to see it a lot in MLA 2500s.....

Best regards,
Gary - AB9M
CSM(r)G.L.Huber
glhuber@msn.com<mailto:glhuber@msn.com>
www.csm-gh.com<http://www.csm-gh.com/>
9679 Heron Bay Road
Bloomington,IL 61704
(309-662-0604)
National Webmaster for:
The Society of the Fifth Division
www.societyofthefifthdivision.com<http://www.societyofthefifthdivision.com/>
----- Original Message ----- From: Jim Brown<mailto:jim@audiosystemsgroup.com> To: Ten Tec List<mailto:tentec@contesting.com> Sent: Wednesday, January 19, 2005 9:25 AM
Subject: [TenTec] Titan 425 Works Fine but Started Blowing Fuses



My vintage 425 just started blowing one of the main 20A fuses for no obvious reason. Yesterday, it had been idling (not in transmit mode) for at least 10 hours and popped the fuse. I didn't realize what had happened until I heard the fan quit. I didn't have time to check it out until last night, when I replaced the fuse and fired it up. No obvious problem, and I ran it for a while, then shut it down for the night. This morning I fired it up again, called a half dozen CQ's on 80 at about 1 kW out (roughly 600 mA plate current, low grid current) and 1:1 SWR, and it popped the fuse again.


The tubes are some "pulls" I bought and installed about 3 months ago, and seem fine. No audible arcing.

Any ideas what to look for?


Jim Brown K9YC



_______________________________________________ TenTec mailing list TenTec@contesting.com<mailto:TenTec@contesting.com> http://lists.contesting.com/mailman/listinfo/tentec<http://lists.contesting.com/mailman/listinfo/tentec> _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec



_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>