Todd,
>From the TT "manual":
"Any high current connections should be made at the 4 pin connector at the
end of the output cable. Pin 1 (black wire) is the chassis ground and high
current return. It is identified by a rib on the plastic shell of the
connector.
Pins 2 and 3 (white wires) are connected in series with the front panel
POWER switch and Cary the "hot" side of the 115/230 VAC line. These two lines
facilitate remote ON/OFF switching of the power supply. Pin 4 (red wire) is
the
=13.5 VDC output."
======================
Hello all, I recently purchased a 962 P/S and no longer have my Omni 6+
manual as I sold the rig. I need to know which wires are +/- on the DC power
cable.
There's white, green, red & black. I'm hooking up my Brand K rig to this P/S
& need to know the right connections.( I can assume white / red is hot,
black
/ green is ground, but we all know the definition of assume, Hi Hi.) I would
just like to be sure. Thanks for any help.
73, Todd - KT0DD - kd7efq@aol.com
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|