Re: [TenTec] Omni VI roofing filter JPG

["Steve N4LQ" <n4lq@iglou.com>]

Be prepared to spend about $200. Small price to pay for an Omni VI+ +.
You get to choose either the SSB or CW roofing filter. The CW filter is 
600hz wide. With the programing switches, you can make it kick in when 
hitting either N-1, N-2 or either.
It matters not if you have any filters in the option slots on the 9mhz 
board.
This thing installs at the very beginning of the 9mhz IF chain, just like 
the Orion. After this filter, the signal hits the OEM 15khz wide filter, 
which has an easy job now, then through the first IF amplifier, which is now 
happy not to have so many sigs to amplify, an on to your optional 9mhz 
filters.
Steve N4LQ
----- Original Message ----- 
From: "John L Merrill" <jmerrill1@adelphia.net>
To: <tentec@contesting.com>
Sent: Tuesday, January 11, 2005 7:44 PM
Subject: RE: [TenTec] Omni VI roofing filter JPG


> what's the cost?
>
> -----Original Message-----
> From: tentec-bounces@contesting.com
> [mailto:tentec-bounces@contesting.com]On Behalf Of Steve N4LQ
> Sent: Tuesday, January 11, 2005 7:38 PM
> To: tentec@contesting.com
> Subject: [TenTec] Omni VI roofing filter JPG
>
>
> Here is the completed installation of the INRAD roofing filter. It mounts 
> on
> the final amp box toward the rear, bottom of the rig. Take a look.
> Oh, It works too. I noticed no loss of gain or increase of noise. With it
> engaged, the 250hz filters become slightly more effective. I have nothing 
> to
> measure BDR or IMD. The next contest will tell the story.
> www.webham.com/INRAD
>
> Steve N4LQ
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec