Maybe TenTec could help you there Deni. I know at some point, TenTec
added a screw to the back center area of the bottom aluminum shield. I
see bypass capacitors installed in various locations. Probably a lot of
tricks have been tried by both TT and owners with varying success.
What alignment are you refering to?
N4LQ
-----Original Message-----
From: "Deni F5VJC" <telegrafiste@tiscali.fr>
To: <tentec@contesting.com>
Date: Mon, 10 Jan 2005 13:46:46 +0100 (Romance Standard Time)
Subject: [TenTec] Omni VI confusion & Birdies?
>
>
>
> Subject: Re: [TenTec] Omni VI confusion
>
> Well sort of...There's lots of little things TenTec did when they came
> out
> with the 564, VI+. For example. The option caused some birdies. They
> cut
> cable 34 between the logic board and 9mhz IF and inserted RF chokes in
> series then put heat shrink tubing over them In the VI+, they rethought
> the
> process and installed a little circuit board with smd parts on it.
> Cable 34
> goes into and out of that.
> =======================
>
> Interesting Steve, are there any known mods to reduce the birdies in
> the
> opt3?
>
> The Omni6 opt 3 alignment went fine btw, thanks.
>
> 73, Deni
>
> F5VJC / GM3SKN
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|