Not quite finished. I believe that InRad suggests that it is advisable to
null the carrier before the job is complete. I have an Omni V rather than
an Omni VI so I'm unable to advise on the procedure. No doubt others will
be able to guide you on this last step,
73,
Rick
VE7TK
Website: http://www3.telus.net/ve7tk
----------------------------
Date: Wed, 05 Jan 2005 18:00:43 -0500
From: "n4lq" <n4lq@iglou.com>
Subject: [TenTec] Adding the 2.8khz filters to Omni VI
To: CROCDONZ1@aol.com, tentec@contesting.com
Message-ID: <E1CmK8x-0002HM-DR@iglou.com>
1. With rig facing you, turn it over.
2. Remove bottom cover.
3. remove bottom shield.
4. On the left rear you have 2 optional filter slots. Don't use those. 5.
There is a filter on the far left (non optional). This is your 2.4khz.
6. Remove this 2.4khz and insert the 2.8khz filer. This completes the 9
mhz filter installation.
7. The filter board on the right is your 6.3mhz IF. It has 4 slots.
8. The far rear one is the non-optional 2.4khz filter.
9. Replace it with your 2.8khz filter.
10 You are done. Don't mess with any jumpers.
steve N4lq
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|