Totally wrong. The 6.3mhz 2.8 goes in the 2.4 slot and the 9mhz 2.8
replaces the stock 2.4 filter. They do not go in the 250hz and N slots.
N4LQ. If I were home and had the book in front of me I would be more
graphic. I have a feeling you didn't remove the bottom of the rig.
Steve
-----Original Message-----
From: CROCDONZ1@aol.com
To: tentec@contesting.com
Date: Wed, 5 Jan 2005 14:54:22 EST
Subject: [TenTec] omni 6 plus question
> i have purchased and installed both of the 2.8 inrad filters. i have
> them
> installed in the 250 hz cw and nar 2 slots. is this ok? the thing i
> have observed
> is when i have them selected, its like i have turned on a 10 db preamp
> as
> well. going back to the stock 2.4 and 1.8, the s meter readings are
> back in line
> with all the other rigs i have. is this normal? did i do something
> wrong? i
> just want to be sure i am not hurting the rigs performance.
>
> thanks
>
> don-kd9mf
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|