The resolderng usually works, 99.9%. Sorry, if it did not, return it.
Its definitely caused by bad soldering on the major loop board. Been
there.
JB N4NQY
> Well the dreaded PLL OUT OF LOCK fault has struck!
>
> My Google search showed three recomendations.
>
> 1) See if the small variable resistor is out of adjustment on the Major
> Loop Board. This did not work.
>
> 2. Resolder ALL the solder trace connections on the Minor and Major Loop
> boards. It was recommeded that I remove the existing solder first. Many
> hours later, after careful comparisons to board image in manual (I had
> to scan it, enlarge it and flip it to see from the back). Checking
> redoing, checking and redoing.... No go.
>
> 3) Send it to Ten-Tec. Ouch, In 30 plus years of owning Ten-Tec
> equipment I've always been able to fix it myself. :(
>
> The problem is on all frequency ranges.
>
> This Paragon has the original Major Loop board.
>
> Any constructive suggestions?
>
> Jerry, KG6TT
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|