Re: [TenTec] Corsair II power connections

["denton" <denton@oregontrail.net>]

pins 2 & 3 go to the power push pull knob in the front of the corsair and 
are only for turning a ten tec power supply on and off
pin 1 is the B=
pin 4 is ground, both chassis and power supply.
with the ampex breaker and astron power supply, you should disregard pins 2 
& 3 and use the circut breaker to turn the cosair on and off..or just leave 
it on all the time.
----- Original Message ----- 
From: "Tim Logan" <nz7c@cox.net>
To: <tentec@contesting.com>
Sent: Wednesday, December 29, 2004 6:14 PM
Subject: [TenTec] Corsair II power connections


> Hi  -
> I'm a little confused about the Corsair II power plug pin connections. I 
> am using an Astron 25 amp PS and I have an Ampex breaker in my power cord. 
> The cord is wired to pin 1 and 4 of the power connection. These 
> connections do not allow me to turn the rig off and on from the front. 
> Page 1-2 of the manual I THINK indicates that you should use pins 2 and 3 
> instead of 1 and 4 if you want to power the rig on and off from the front. 
> Is that correct or am I misreading the manual. Thanks for any help with my 
> dopey question!
> 73/Tim NZ7C
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec


_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec