| To: | <tentec@contesting.com> |
|---|---|
| Subject: | [TenTec] Binaural CW for Tentec rigs - an easy way |
| From: | <k7gt@charter.net> |
| Reply-to: | tentec@contesting.com |
| Date: | Wed, 29 Dec 2004 16:15:54 +0000 |
| List-post: | <mailto:tentec@contesting.com> |
An easy way to add binaural CW would be to get a Timewave 599ZX DSP box. The current firmware has a binaural CW mode. I have seen these DSP boxes available used for ~150-200 dollars. The new firmware chip, if out of date on the unit, is about $60 from Timewave. 73 Allan K7GT _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: Re: [TenTec] Adding Binaural CW to Ten-Tec transceivers, Jeff Kelly |
|---|---|
| Next by Date: | Re: [TenTec] Adding Binaural CW to Ten-Tec transceivers, Jerry Volpe |
| Previous by Thread: | [TenTec] Still looking for RS-232 interface for my Paragon, Jerry Volpe |
| Next by Thread: | Re: [TenTec] Binaural CW for Tentec rigs - an easy way, Jerry Volpe |
| Indexes: | [Date] [Thread] [Top] [All Lists] |