Hi Mark and Group,
Using a mic with XLR such as the Goldline wire it as follows:
XLR = Pin # 1 (shield/gnd) to mic connector case - this shield wire comes
back out of
the connector and is secured by wrapping
it
around one of the screws you tighten
down
to hold the mic cord in place.
XLR = Pin # 2 This is the Audio Send (+) it wires to Pin # 1 on the Orion
mic connector.
XLR = Pin # 3 This is the Audio Return ( - ) it wires to Pin # 2 on the
Orion Mic connector
If you are using a Foot Switch or separate PTT switch: wire as follows:
PTT or Foot Switch wire one side to Pin # 3 on the Orion mic connector, the
other wire wires to the shield (chassis ground) at the Orion mic connector.
Or
You can bypass the mic connector all together for the PTT or Foot Switch and
use the AUX I/O as shown on page 28 of the Orion's Operations Manual.
Or
You can use the CW 1/4" phono plug on the front of the Orion and in Menu
under CW change
SSB: CW Jack PTT = On. (this is what I use)
If I can be of further help let me know
John / N0KHQ / St. Louis
_______________________________________________
Orion mailing list
Orion@contesting.com
http://lists.contesting.com/mailman/listinfo/orion
|