Re: [TenTec] Omni VI Opt. 3 Stopped Transmitting

["Alan Zaur" <AlanZaur@Adelphia.Net>]

Scott:

Did you try re-seating the jumper plug in the keying loop in the back of the 
transceiver that is intended to connect to a linear amplifier.  Occasionally 
that jumper will become unseated an render the transmitter inoperable.  Just 
pull the jumper, wipe the contacts with something mildly abrasive, and 
re-install.

Alan K1MZM
----- Original Message ----- 
From: "Scott Walker" <N3SW@worldnet.att.net>
To: <tentec@contesting.com>
Sent: Saturday, December 11, 2004 16:25 PM
Subject: [TenTec] Omni VI Opt. 3 Stopped Transmitting


> The radio stopped keying right in the middle of a CW traffic net last 
> night.
> Sidetone works.  Receiver is fine.  I got no power output on any band in 
> any
> mode.
> I tried it again after a night's rest, and at first it worked.  Then after
> about ten minutes, same deal, no transmit.  I did a partial reset of the
> processor without improvement.  Then I did a full reset without 
> improvement.
> As of now, it won't transmit in any mode regardless of how long I rest it.
> I plan to call TenTec on Monday for suggestions.  I thought I would ask 
> for
> ideas on here as well.
> Thanks in advance for any pointers.
> -Scott N3SW
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec 

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec