RE: [Orion] Firmware upgrade and CW/ACOM2000A issue again

["Richard Detweiler" <rdetweil@hotmail.com>]

I don't know the way the Acom is connected,

However, there are a couple of controls that will lengthen the delay between 
the amplifier action and the start/end of the signal.

These are the "EXT T/R Delay 1" and 2 in the TX menu and the "CW QSK Delay" 
in the CW menu.

The 1st is for Non QSK set up,  the second is for a QSK set up.

Read up on those two and see if they will help solve the problem.

thanks
Rich
K5SF

> From: n1eu@netscape.net (Barry N1EU)
> To: tentec@contesting.com, Orion@contesting.com
> Subject: RE: [Orion] Firmware upgrade and CW/ACOM2000A issue again
> Date: Sat, 04 Dec 2004 07:53:42 -0500
>
> "Sergei Kulyov" <ua3ap@smtp.ru> wrote:
>
> >Does anybody got an issue while in CW keying ACOM2000 after
> >upgrade to 1.372? My ACOM immediatly fails to transmitt
> >with "ARC fault" alarm althouth I'm using it in QSK mode.
>
> Sergei, my Orion seems to key my Acom 2000A perfectly with v1.372.  Sorry 
> to hear of your troubles.
>
> 73,
> Barry N1EU
>
> __________________________________________________________________
> Switch to Netscape Internet Service.
> As low as $9.95 a month -- Sign up today at 
> http://isp.netscape.com/register
>
> Netscape. Just the Net You Need.
>
> New! Netscape Toolbar for Internet Explorer
> Search from anywhere on the Web and block those annoying pop-ups.
> Download now at http://channels.netscape.com/ns/search/install.jsp
> _______________________________________________
> Orion mailing list
> Orion@contesting.com
> http://lists.contesting.com/mailman/listinfo/orion


_______________________________________________
Orion mailing list
Orion@contesting.com
http://lists.contesting.com/mailman/listinfo/orion