TenTec
[Top] [All Lists]

Re: [Orion] Orion mic input question

To: w9ge <finger@goeaston.net>
Subject: Re: [Orion] Orion mic input question
From: Joe Giacobello <k2xx@swva.net>
Reply-to: k2xx@swva.net
Date: Mon, 22 Nov 2004 13:55:02 -0500
List-post: <mailto:orion@contesting.com>
Bob, I watch my Orion's transmitted audio carefully on a scope and I run the mike gain wide open using the TT studio mike or a Heil dual cartridge (4/5) mike, and I never come close to flat topping. I have not actually observed the dead span between 15-100, but now that you bring it up, I'll take a look.

73, Joe

w9ge wrote:

I have finally, after a year, hooked up my scope to the rf chain from my Ten Tec Orion. It appears the mic gain setting has no affect after turning it past "15". I have been running my Heil HC4 element with mic gain at 65 with no known ill effects, and noticed the same on the scope with it as with a two tone test signal inserted in the mic jack. No change in rf output with mic gain set anywhere between 15 and 100. I can vary rf power out with the power control just like on cw.

Is the Orions internal ALC for mic gain that good? Or am I missing something? If what I see on the scope is correct it is likely almost impossible to overdrive the Orion on voice. I appreciate the wisdom of ssb ops who know more than I about mics and mic inputs etc. thanks. 73 bob de w9ge _______________________________________________
Orion mailing list
Orion@contesting.com
http://lists.contesting.com/mailman/listinfo/orion





_______________________________________________
Orion mailing list
Orion@contesting.com
http://lists.contesting.com/mailman/listinfo/orion

<Prev in Thread] Current Thread [Next in Thread>