| To: | <k2xx@swva.net>, <tentec@contesting.com> |
|---|---|
| Subject: | Re: [TenTec] N4PY Orion Control Program Version 1.12 Released |
| From: | "Tommy" <aldermant@alltel.net> |
| Reply-to: | tentec@contesting.com |
| Date: | Tue, 9 Nov 2004 19:35:03 -0500 |
| List-post: | <mailto:tentec@contesting.com> |
|
Just a small observation...the speed of the CPU has very little, if
anything to do with the speed of the serial port. If your need
faster I/O speeds, it's probably best to look at using USB 2.0 ports
instead of serial ports. Tom - W4BQF ----- Original Message ----- From: "Joe Giacobello" <k2xx@swva.net> To: <tentec@contesting.com> Sent: Tuesday, November 09, 2004 7:07 PM Subject: Re: [TenTec] N4PY Orion Control Program Version 1.12 Released Jerome, I've observed this same problem with the O(rion control software. It's sometimes difficult to fine tune a station because one tends to overtune or overshoot the signal. Carl has said that it's because of the speed bewteen the radio and the computer serial port. I recently upgraded from a 450 MHz to a 2.2 GHz machine and there was little, if any, improvement, suggesting that Carl's assessment is probably accurate.
|
| Previous by Date: | Re: [TenTec] N4PY Orion Control Program Version 1.12 Released, Joe Giacobello |
|---|---|
| Next by Date: | Re: [TenTec] QSK with QSK-5PC, Steve N4LQ |
| Previous by Thread: | Re: [TenTec] N4PY Orion Control Program Version 1.12 Released, Joe Giacobello |
| Next by Thread: | Re: [TenTec] N4PY Orion Control Program Version 1.12 Released, Dudley Hurry |
| Indexes: | [Date] [Thread] [Top] [All Lists] |