If it isn't changing freq, rule out about everything you mentioned. Check
out the display board and reseat the connectors, tighten screws, etc.
Phil C.
K4DPK
----- Original Message -----
From: "Adam N." <adam2@n4ekv.com>
To: <tentec@contesting.com>
Sent: Tuesday, November 02, 2004 5:27 PM
Subject: [TenTec] 544 freq display jumping on TX
> I have a nice 544 that has a problem where the freq readout jumps around
> while transmitting on some bands (15m comes to mind). It does not seem
> to be changing my actual output freq.
>
> When I use the remote VFO (for TX and RX) the problem stops.
>
> I've read through the archives on this reflector at some possible causes
> (PTO rebuild, dirty band switch, unstable osc) but I'm not sure which to
> attach first.
>
> Thanks in advance.
>
>
> 73,
>
> Adam N.
> N4EKV
> Oakland, CA
> www.n4ekv.com
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|