Phil,
Not nit-picking here, but why would the specs leave out insertion
loss ? One of the most important specs for anything after your final
RF output device. Also interesting that very few manufacturers
include both insertion loss and port to port isolation for coax
switches. Gotta be a good (hidden) reason for doing that ?
Tom - W4BQF
----- Original Message -----
From: "Phil Chambley, Sr." <k4dpk@comcast.net>
To: <tentec@contesting.com>
Sent: Monday, November 01, 2004 8:35 PM
Subject: Re: [TenTec] B&W low pass filter rating
> Jim...
> Cutoff freq 34 mhz
> Max atten freq 52 Mhz
> Min atten (dB) 70
> Impedance 50 ohms
> Power rating 1500 watts
>
> 73
> Phil Chambley (friend of Ed MacKenzie)
> K4DPK
> ----- Original Message -----
> From: "tuscola" <tuscola@tds.net>
> To: <TenTec@contesting.com>
> Sent: Monday, November 01, 2004 6:05 PM
> Subject: [TenTec] B&W low pass filter rating
>
>
> Hi, since Scott brought up his request for a low pass filter and
different
> models are being brought up, I thought that someone might be able
to help
> me with the rating on a B&W low pass filter with a model #425,
S.N. 101,
> picked this up at Dayton a summer or so ago and there is no rating
on it.
> Tnx jim heath w8ngo
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|