A dangerous situation since meter movements are very delicate. I would try
a drop of watch oil in each end if the shaft, a drop from a toothpick might
help. I used to rebuild speedometers when they were mechanical and this is
what I used on them.
----- Original Message -----
From: "Irena & Richard Jenkins" <richard.jenkins@internode.on.net>
To: <tentec@contesting.com>
Sent: Saturday, October 23, 2004 12:34 AM
Subject: [TenTec] Meter Problem
> I was 'too generous' with the spray when cleaning up a nuisy pot. control
on
> my Argosy. After doing the job I have found the S-meter is very stiff ...
> and not working as it should. What is the next (restorative) action ...
> would a careful spray with WD-40 (or similar) loosen it up so it works
> again??
>
> Richard
> --
> --
> Irena & Richard Jenkins VK1NDV & VK1RJ
> Canberra, AUSTRALIA
> ====================================================
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|