That is quite right. Personally, I would not lose any sleep over the
"missing" crystals as they were optional and only cover the top end of the
ten meter band.
So you miss out on FM, which you can not receive anyway, and the satellite
activity up around 29.375. If you are not a sat op, you don't need the
crystals.
Hope this helps. You can no doubt get the crystals from TenTec or have them
made to order.
73 =paul= W8KC
-----Original Message-----
From: tentec-bounces@contesting.com [mailto:tentec-bounces@contesting.com]
On Behalf Of doc
Sent: Saturday, October 16, 2004 8:38 PM
To: tentec@contesting.com
Subject: Re: [TenTec] 10M Crystal Freqs in the 540?
Paul - W8KC wrote:
> TWO? There are FOUR 10M crystals in a fully configured 540 or 544.
>
> Which two of the four are you missing?
The two socketed ones. Two are soldered in. Someone E-mailed me the
following privately:
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
They are NOT HC-6. They are the smaller HC-25 U.
The xtal for 29 to 29.5 MHz is 14.990 MHz. - model 212
The one for 29.5 to 30 MHz is 15.490 MHz -- model 213
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
--
Thanks! & 73, doc kd4e
West Central Florida 100% Linux. Suse 9.1
Drake, Hallicrafters, Heathkit, TenTec, Yaesu
Radio Life: http://www.gospelcom.net/twr/
Linux-Incompatible hardware is defective!
"...a plan is not a litany of complaints."
USA Pres. Election 2004: http://www.rnc.org/
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|