I use an ACOM 1000 with my Orion. I use the keying loop and have no
problems at all. It works well. By the way, when using the keying loop,
there are no timing parameters to set. The only timing parms are for the
"Amp Key" line which is not used for the keying loop connection.
Carl Moreschi N4PY
Franklinton, NC
----- Original Message -----
From: "Richard Markel" <richard@batnet.com>
To: <tentec@contesting.com>
Sent: Sunday, October 10, 2004 10:53 PM
Subject: [TenTec] Orion and Acom 1000
> I have had an Orion for a short time and quite happy with it so far. I
> plan on running it with an Acom 1000. Do I take it that all compatibility
> problems have been ironed out if there were any in the first place? If
> using the Orion's keying loop, will I have to change the times via the
> Orion's menu?
>
> Thanks in advance
>
> KB6VT - new user
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|