Yes, but the low frequencies will get by fine. It's the higher frequencies
that will be attenuated. I think if you remove the 0.1, you will find the
rx320 and Orion receive the same in this DRM application.
Carl Moreschi N4PY
Franklinton, NC
----- Original Message -----
From: "Mark Erbaugh" <mark@microenh.com>
To: <tentec@contesting.com>
Sent: Friday, October 01, 2004 9:01 AM
Subject: Re: [TenTec] Orion and RX-320 on DRM
> Carl,
>
> > Yes, the cap is attenuating the signal. Normally caps are used to
bypass
> RF
> > signals for audio signals. A 0.1 cap is large even for 12 kHz.
>
> I'm not having a problem with not enough signal. Even with the cap in
place,
> I still need to back down on the soundcard input level to keep the input
> from overloading.
>
> 73,
> Mark
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|