The Jupiter, Pegasus, and Orion have the TXCO as standard.
Carl Moreschi N4PY
Franklinton, NC
----- Original Message -----
From: "John Clifford" <johnclif@ix.netcom.com>
To: <johnclif@ix.netcom.com>; <tentec@contesting.com>
Sent: Thursday, September 30, 2004 4:11 AM
Subject: [TenTec] Jupiter/Orion freq stability...
> I know that the Argonaut has a TXCO option, but does this come standard on
> the Jupiter and Orion?
>
> On the Omni VI and VI+, the BFO board xtals are not tied into the 10 Mhz
> reference xtal and are a source of frequency instability (abeit within the
> rig's published specs). Do the Jupiter and/or the Orion handle this
> differently so that one master frequency reference is used throughout the
> rig? Do both of these rigs use a 10 Mhz reference frequency so that it
> would be possible to use them with an external frequency reference (like
the
> surplus HPs out there)?
>
> - jgc
>
> John Clifford KD7KGX
>
> Elecraft K2 #1678 /KSB2/KIO2/KBT2/KAT2/KNB2/KAF2/KPA100
> Ten-Tec Omni VI/Opt1, Centaur, 238B
> Alinco DR-605TQ, DJ-V5
> Icom T90A
>
> IRLP #3978
>
> email: kd7kgx@arrl.net
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|