Re: [TenTec] DC Cable for Triton IV -- 540?

[Charles Greene <W1CG@QSL.NET>]

Hi,

You guys are making me very curious about which connector the Trident IV 
has, so I went down and looked at mine.  The rig, a model 540, analog, has 
a 6 pin Jones Plug.  The power supply, a model 262G has a 4 pin Molex plug.

73,

Chas, W1CG

At 05:18 AM 9/29/2004, you wrote:
> I had a Triton IV that had the Jones 6 pin cable also. I don't remember the
> serial #.
>
> Lee K2BLC
>
> ----- Original Message -----
> From: "Paul Valko - W8KC" <w8kc@comcast.net>
> To: <tentec@contesting.com>
> Sent: Tuesday, September 28, 2004 11:53 PM
> Subject: Re: [TenTec] DC Cable for Triton IV -- 540?
>
>
> > Mike,
> >
> > Was that a used rig?  My early Triton IV digital has the same 4-plug MOLEX
> > connector every other Triton/Omni/Corsair and matching power supply has.
> >
> > In other words, I've never seen a six wire Molex on any Ten-Tec.  I can't
> > imagine TT would have put a six pin plug on a power supply without
> changing
> > the model number.
> >
> > And to the other ham, no.  There is no difference in plugs due to the
> > digital display.  The four connectors are +12vdc, ground, and two to
> control
> > AC power from the Triton's power switch.
> >
> > 73! =paul= W8KC
> > Collector of Ten*Tecs and other fine plastics.
> > Visit the Virtual Ten*Tec Museum at http://mywebpages.comcast.net/w8kc
> > Listen to 7.040 MHz from anywhere with Media Player v9
> > http://www.w8kc.com/stream.asx
> >
> >
> >
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec


_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec