[TenTec] Corsair II working fine now

[Jim <GIJoe44@comcast.net>]

First would like to say thanks for everyones help on hooking up the 
internal keyer.
I figured that out right away, but what was going on, it would send dits 
 constantly when I jumpered the keyer out to key jack.  I was afraid 
for the worse, but hearing that these rigs are easy to work on cracked 
the case.  Turns out the wire from the paddle dit to the board where 
keyer chip is was caught under one of the screws holding down another 
board.  This over time I guess had wore and now the dit was grounded at 
that point.  I set that wire free and now, YES!!! keyer is FB....

Thanks again for all the help..

73,

Jim  KU4QW

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec