RE: [TenTec] Ten Tec knobs

["EDWARD CRAWFORD" <w4wvw@msn.com>]

On the 229 tuner I had it looked like the knobs they used did not fit the 
shafts so they ground off one side of the shaft which left it in a 
triangular shaped mess so the knobs would fit on. Looked   kind of pitiful.
73. Ed, w4wvw


> From: "Paul DeWitte K9OT" <k9ot@mhtc.net>
> Reply-To: tentec@contesting.com
> To: <TenTec@contesting.com>
> Subject: [TenTec] Ten Tec knobs
> Date: Mon, 23 Aug 2004 07:58:40 -0500
>
> We purchased a tuner from TT a couple of years ago and one of the knobs was
> no good out of the box.
> Since they refuse to put brass inserts in their knobs, there is a couple
> ways around this.
> One is replace all of the knobs with Radio Shack or some other brand right
> away and when you sell it put the T T knobs back on.
> Another way to fix cracked ones is to put the wire around the inside part
> and pull it back in shape and then fill the space between the outside and
> inside with epoxy. Dont epoxy the screw.
> Another way is to buy a brand X radio (unthinkable)
> 73 Paul K9OT
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec


_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec